Käyttöohje PHILIPS SBC-HC8300

[. . . ] Automatic power on/off indicator The FM transmitter automatically switches on and starts transmitting when audio signals are detected at the audio input (red LED). When no audio signals are detected the FM transmitter automatically switches off after a few minutes. Easy transmission The FM headphone is able to receive signals from the transmitter, even through barriers such as doors, walls and windows. General information Multiple headphones with one transmitter An additional number of headphones and/or wireless speakers can be used with a single transmitter if they: - operate in the 864 MHz band - can detect a 19 kHz pilot tone. Please consult the appliance's electrical specification sheets for confirmation on compatibility. Controls Transmitter (figure 1) 1 Power indicator ­ lights up when audio signals are detected at the audio input. [. . . ] 2 Ensure the batteries are put in the battery compartment correctly according to the engraved polarity symbols. ­ Always remove the batteries if the headphone is not to be used for a long period of time. Batteries contain chemical substances, so they should be disposed of properly. Hearing Safety!Continuous use at a high volume may permanently damage your hearing. Environmental Information All redundant packing material has been omitted. We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment. Installation Headphone battery replacement (figure 3) IMPORTANT Use only rechargeable LR03/AAA NiMH batteries (preferably Philips). Do not use NiCd batteries or alkaline batteries as these may damage your FM wireless system!1 Open the headphone's battery compartment. 2 Take out the batteries and dispose of them properly. Only use LR03/AAA NiMH batteries (preferably Philips). 4 Make sure the batteries are correctly inserted as indicated by the engraved symbols in the battery compartment. IMPORTANT Before using the FM headphone for the first time, please ensure that the batteries are fully charged for about 16 hours. This will guarantee a longer operating lifetime of the batteries. Connecting the FM transmitter to a headphone output of an audio source (figure 4) 1 Connect the 3. 5mm stereo plug of the stereo audio cable to the headphone output of an audio source, such as TV, HiFi or PC. ­ In case your audio source has a 6. 3mm headphone output, use the supplied 3. 5mm to 6. 3 mm stereo adapter plug. Audio Connections 2 Switch on your audio source and carefully increase the volume of the audio source. The red power indication LED of the transmitter lights up if receiving an audio signal. 3 Switch on the headphone. You may hear a hissing sound through the headphone if the headphone is not yet properly tuned to the transmitter. [. . . ] Some transmitters already built into other equipment may not be compatible with the HC8305 headphone because of the advanced technologies used in the HC8305 headphone. ­ If the headphone will not be used for a long time, please remove the batteries to prevent leakage and corrosion. ­ Do not leave the headphone near heat sources. [. . . ]